Phone Number

+8675529071623

Accessories

to 260cm OBD2 16-Pin Splitter Extension Cable — 1 Male Female

600 mm flexible flat OBD2 lead with one 16-pin male and two female ports, wired through all 16 pins. Ports share supply and data lines; confirm simultaneous-device compatibility. No voltage/…

Product overview

This 600 mm OBD2 extension/splitter brings a vehicle’s 16-pin port to two female connections for easier equipment positioning and routing. It is a passive electrical pass-through, adding no code-reading, decoding or voltage conversion. Both ports share vehicle supply and communication lines; simultaneous operation depends on the vehicle and connected devices.

Key capabilities

One male, two female, all-pin pass-through

Standard 16-pin connections and full-pin wiring pass existing signals for compatible OBD2 equipment, including CAN supported by the vehicle/tools. Physical fit does not establish every software or vehicle function.

Extended access for routing

A flexible flat lead of about 60 cm moves diagnostic access to a convenient position. Route clear of pedals, steering, heat and moving parts, without pulling or crushing connectors.

Shared lines require compatible equipment

The female ports do not provide independent isolation, supplies or bus arbitration. Two active diagnostic tools may affect one another and their power load is shared by the vehicle port. Check both tool instructions first.

Suggested workflow

  1. Check connections and ratings — Verify the vehicle port, tool pinout and power requirements and whether simultaneous connections are needed.

  2. Connect and route as instructed — Connect in the vehicle/tool’s prescribed state without forcing plugs; secure the lead away from driving controls.

  3. Verify devices before simultaneous use — Verify each device’s power/communication separately, then connect together only under compatible conditions. Disconnect and check individually if problems occur.

Frequently asked questions

Will two scanners always work without interference?

No. Both ports share the bus and supply; concurrent requests/control commands may conflict. Confirm vehicle/tool support and do not treat the splitter as two independent diagnostic channels.

Does it convert voltage or unsupported protocols?

No. It passes existing pin connections without voltage conversion, protocol conversion or added vehicle functions. Devices must still match the vehicle’s electrical and protocol conditions.

Can cables be chained without limit?

No. Extra length and contacts add resistance/voltage drop and can affect signal quality. Confirm permitted extension and length with vehicle/tool requirements.

Product design

OBD2 16-Pin 2-in-1 Cable Product design

Documentation and support

View product documentation and contact technical support

Key features

600 mm flexible flat OBD2 lead with one 16-pin male and two female ports, wired through all 16 pins. Ports share supply and data lines; confirm simultaneous-device compatibility. No voltage/protocol conversion.

Applications

60cm OBD2 16-pin splitter cable, 26 AWG, one male to two female, all-pin pass-through. Extend diagnostic access with guidance on shared power/data and chaining.

Technical specifications

ItemSpecification or function
ProductOBD2 16-pin splitter extension cable
Connector layout1 male → 2 female
Length600 mm / 60 cm, approx. 24 inches
Pin wiringAll 16 pins pass through
Wire gauge26 AWG per product illustration
Conductor/formCopper conductors, flexible flat lead
Signal connectionPassive existing OBD2 signal pass-through, including compatible CAN lines
Port relationshipShared supply, grounds and data lines; not independently isolated
Compatibility requirementVerify 16-pin fit and vehicle/device electrical/protocol requirements

Passive splitting provides no voltage/protocol conversion. Verify simultaneous use and extension limits against vehicle/tool requirements; arbitrary combinations are not guaranteed interference-free.

60cm OBD2 16-Pin Splitter Extension Cable — 1 Male to 2 Female